SF6 density relay

评论

发表评论

此博客中的热门博文

Working principles of SF6 gas density table

图片
  1. When the density meter is not installed, if the ambient temperature is 20 ℃, the pointer 2 points to 0MP, but if the ambient temperature is not 20 ℃, because the double-layer metal belt 3 is in accordance with the ambient temperature and 20 ℃ difference to compensate So that when the ambient temperature is higher than 20 ° C, the double-layer metal strip 3 is elongated and its lower end is displaced in the direction of 5, causing the gear mechanism and the pointer 2 to move in the direction in which the density or pressure indication value decreases, The reading of the pointer 2 is greater than 0MP; otherwise, when the ambient temperature is below 20 ° C, the gear mechanism and the pointer 2 will move in the direction of increasing the density or pressure indication value. 2. When the SF6 gas is charged to the circuit breaker , the end of the elastic metal pipe 1 is displaced in the direction of 4 as the gas pressure is gradually increased, and the double-layer metal strip...
阅读全文

The introduction of SF6 Gas Density Relay

SF6 density relay Gas pressure meters for SF6-gases are pressure gauges with electrical accessories, mainly for switching equipment in the energy industry. It sets the pressure measurement and limit switches in one device. The effect of ambient temperature is adjusted by a special compensation system. The densitometer is calibrated according to the fill pressure, calibration pressure, switch point and ambient temperature in the case of use. The instrument can provide indoor models, can also be used for outdoor inflatable or filling type. sf6 gas density monitor , SF6 gas density monitor with SF6 gas density relay, SF6 gas density monitor with SF6 gas density relay, SF6 gas density relay, SF6 gas density monitor with SF6 gas density relay, With temperature compensation SF6 gas density relay, without temperature compensation SF6 gas density controller, high precision SF6 gas density monitor and so on.
阅读全文

Why should the power sector carry out the SF6 gas density relay check?

图片
SF6 gas density relay calibration is the power sector must do the test, which appeared specifically for the SF6 gas density relay calibration instrument-SF6 gas density relay calibrator. Why should the power sector carry out the SF6 gas density relay check? SF6 switch is widely used in power systems, high voltage electrical appliances, SF6 switch reliable operation has become one of the most concerned about the electricity sector. SF6 gas density relay is used to monitor the SF6 switch in the body sf6 gas density monitor changes in the important components, its performance directly affects the SF6 switch running safe. SF6 gas density relay operating on the site due to lack of action, after a period of time often occurs when the action is not flexible, poor contact and other phenomena, and some will appear density relay temperature compensation performance deterioration, when the ambient temperature mutation often lead to SF6 density Relay malfunction. Therefore, DL / T596-1996 ...
阅读全文